khal v0.2 released
******************

A new release of khal is here: khal v0.2.0 (also available on pypi).

If you want to update your installation from pypi, you can run *sudo
pip install --upgrade khal*.

From now on *khal* relies on vdirsyncer for CalDAV sync. While this
makes *khal* a bit more complicated to setup, *vdirsyncer* is much
better tested than *khal* and also the bus factor increased (at least
for parts of the project).

You might want to head over to the tutorial on how to setup
*vdirsyncer*. Afterwards you will need to re-setup your *khal*
configuration (copy the new example config file), also you will need
to delete your old (local) database, so please make sure you did sync
everything.

Also *khal*'s command line syntax changed quite a bit, so you might
want to head over the documentation.
